User's Manual

Smart Machine Smart Decision
2 RXD O Receive Data
3 TXD I Transmit Data
4 DTR I Data Terminal Ready
Attention: The ignition of T5320+G
Terminal is activated via a rising
edge of high potential (+3 ... +15 V)
5 GND - Ground
6 DSR O Data Set Ready
7 RTS I Request To Send
8 CTS O Clear To Send
9 RING O Ring Indication
Note: User can use AT command “AT+IPR=x” to set a fixed baud rate and the setting will be saved to
non-volatile flash memory automatically. After the configuration is set as fixed baud rate, the URC such as
"RDY", "+CFUN: 1" and "+CPIN: READY” will be reported when T5320+G is powered on.
Hyper terminal usually as the PC software tool to operate T5320+G; customer can set up a connection between
PC and terminal, configure the port properties as the figure 9 shows.
Figure 10: COM port properties of the hyper terminal
6.3
10 PIN I/O interface
T5320+G_User Guide_V1.01 17 2013-04-15
T5320+G provides a 10 PIN I/O interface for customer use, including Audio, GPIOs and 1 ADC channel.