User's Manual

Smart Machine Smart Decision
SIM5320ALD_User Manual_V1.01 2014-08-20
46
Figure 37: Reset circuit
Note ： 50ms<t<200ms. ESD components are suggested to be used on Reset pin.
3.10.3 ADC
SIM5320ALD has a dedicated ADC that is available for digitizing analog signals such as battery voltage
and so on; it is on PIN 47 and PIN 46 , namely ADC1 and ADC2 . This ADC is 12 bit
successive-approximation circuit, and electronic specification is shown in the following table.
Table 32: Electronic Characteristics
Specification Min Typ Max Unit Comments/Conditions
Resolution 12 Bits
Differential nonlinearity -4 +4 LSB
Analog Vdd = ADC reference
2.4MHz sample rate
Integral nonlinearity -8 +8 LSB
Gain Error -2.5 +2.5 %
Offset Error -4 +40 LSB
Input Range GND 2.2V V
Input serial resistance 2 kΩ Sample and hold switch resistance
Input capacitance 53 pF
Power-down to wakeup 9.6 19.2 μs
User can introduce a signal in the ADC pin directly and use the AT command “AT+CADC” to get the raw
data which is between 0 and 4095. The data can be transformed to any type such as voltage, temperature
etc. Please refer to document [1].
Figure 38: Reference circuit