User's Manual

ManualsBrandsShanghai Simcom ManualsCell Phones911 MOBILE PHONE

911 Phone Product Descriptions

Use Conditions

Ambient temperature -20℃～ +60℃

Relative humidity 0％～95％

Atmospheric pressure 86～106Kpa

Working frequency GSM 850/1900

Quick Installation

1. Open the battery compartment cover in the bottom of the phone; insert

the battery into the battery compartment based on polarity direction in

the drawings.

2. Refit the battery compartment cover; make the screw in well state.

Understand your phone

1. 911 key: Long press this key for about 3 seconds to turn on the

phone, search the network and automatically dial “911”. In

addition, this key is used as “1” key in the conversation.

2. End key: Long press this key for about 1 second to turn off the

phone (except for battery power in display state)

3. Check the battery power key: Long press this key to display the

battery power

4. Volume－ key: Press this key in the conversation to decrease volume.

Summary of content (4 pages)

PAGE 1
911 Phone Product Descriptions Use Conditions Ambient temperature -20℃～ +60℃ Relative humidity 0％～95％ Atmospheric pressure 86～106Kpa Working frequency GSM 850/1900 Quick Installation 1. Open the battery compartment cover in the bottom of the phone; insert the battery into the battery compartment based on polarity direction in the drawings. 2. Refit the battery compartment cover; make the screw in well state. Understand your phone 1.
PAGE 2
5. Volume＋ key: Press this key in the conversation to increase volume. 6. The firmware upgrade interface. 7. Headphone jack. Quick use introduction Dial “911” for help Long press 【911】for about 3 seconds to turn on terminal, accompanied with vibrating alert, after completed the network search, play the voice prompt “calling 911” and automatically dial “911”.
PAGE 3
Nearby the electronic equipment controlled by high precision, please turn off the phone, otherwise, cause electronic equipment failure. The equipment may be affected by the phone, including hearing aid, pacemaker, fire-alarm, automatic gate and other automatic control equipments. Users who use medical auxiliary equipment should contact with the equipment service and confirm the effect of radio wave on the equipment.
PAGE 4
for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the government-adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. (Body-worn measurements may differ among device models, depending upon available accessories and FCC requirements.