User's Manual
Table Of Contents
- 1. Introduction
- 2. Technical Parameter
- 3. Outside View and Packaging
- 4.Function Interface
- 4.1 Power Input
- 4.2 Keyboard
- 4.3 LCD & Touch Panel
- 4.4 IC Card
- 4.5 SAM Card
- 4.6 Magnetic Card
- 4.7 Buzzer
- 4.8 Serial Port
- 4.9 USB
- 4.10 T-Flash
- 4.11 Indicator
- 4.12 Printer
- 4.13 Battery
- 4.14 RTC
- 4.15 Power Switch
- 4.16 GPRS
- 5. Installation and adjustment
- 6. Repairs and maintenance
- 7. System components
- 8. Complete set
- 9. Safety precautions
- 10. SAR Info
Prohibited demolition at dangerous places, installing the battery pack.
7. System components
PS4000 for portable electrical equipment, no correlation equipment.
8. Complete set
Supporting the use of the following products:
ADP036-094B Power Supply
Thermal paper (57 × 40mm)
9. Safety precautions
Read carefully before using this manual, the proper use of this product. Please
keep this manual to properly check in at any time convenient place.
When using this product should note the following:
Product failure by the manufacturers maintenance, user shall not change the
product mix.
Product installation, use manual and maintenance should also comply with
product instructions.
In the daily cleaning of the product should be used with a soft damp cloth, not use
silk, chemical fiber fabrics easily lead to static electricity.
Product charging must be in safe areas.
10. SAR Info
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Designed and manufactured not to exceed the emission limits for exposure to
radiofrequency (RF) energy set by the Federal Communications Commission of the
13