User's Manual
Table Of Contents
- 1. Introduction
- 2. Technical Parameter
- 3. Outside View and Packaging
- 4.Function Interface
- 4.1 Power Input
- 4.2 Keyboard
- 4.3 LCD & Touch Panel
- 4.4 IC Card
- 4.5 SAM Card
- 4.6 Magnetic Card
- 4.7 Buzzer
- 4.8 Serial Port
- 4.9 USB
- 4.10 T-Flash
- 4.11 Indicator
- 4.12 Printer
- 4.13 Battery
- 4.14 RTC
- 4.15 Power Switch
- 4.16 GPRS
- 5. Installation and adjustment
- 6. Repairs and maintenance
- 7. System components
- 8. Complete set
- 9. Safety precautions
- 10. SAR Info
4.12 Printer
Picture 4-3
PS4000 printer adapts mini thermal printer with low power consumption. The
paper roller is at front of the terminal with its size is 58mm (W) and 40mm (D).
Please put in the paper roller when use. Lift the small cover in the print paper
cover lightly, open the paper container, put in the paper roller, pull out certain length
of the paper and press it closely to and at middle of the paper cutter, then press the
paper cover tightly and make sure the paper roller stuck in the printer, pull the paper
out certain length to check if is installed correctly. (or select paper feed in the main
menu and make the printer work for a few seconds).
Attention: There is paper lack detection and over heat protection in the printer,
please operation following what the screen tells.
4.13 Battery
Main battery locates at the back of the POS terminal, press the clip to open the
battery container. Please put out the battery if no use for long time.
10