User's Manual

6
23
PRELIMINARY CHECKS
Step 4: Install the remote control unit
Connect the remote control cable to the massage chair’s port found in the side
of the seat, being careful to line up the pins. Do not force. Then tighten the screw
cap clockwise to secure the connector in place.
(Check the illustration below for reference
)
Step 5: Other Accessories
Connect the power cord to the power box of the product.
Plug the power into a grounded three prong socket, switch on the power,
use the remote control to start operation
.
Port for controller line
Screw
cap
Connector of controller line
NAME AND FUNCTION OF EACH COMPONENTS
The remote control will give a single short beep sounds when press
the buttons.
The remote control will give short beeps to indicate that limit
position is reached when incline or recline the backrest.
Please do not play with the backrest incline/recline button to
avoid fault.
CAUTION
Press and hold to extend the footrest, release the button to stop.
(Make sure there is no obstruction in advance)
Footrest Extends
Press and hold to retract the footrest, release the button to s top.
Footrest Retracts
Press and hold on Position UP/DOWN button to adjust the rollers
to the desired position while under manual program or 4D Partial/
Point massage mode
.
Press and hold on Position UP/DOWN button to adjust the rollers
to the desired position while under the body scan procedure.
Shoulder Position Adjust (Moves mechanism up and down)
While massage program is running, press this button to change the
4D protruding intensity.
4D Massage
Press and hold to raise the Legrest, release the button to stop .
Feet Up
Press and hold to lower the Legrest, release the button to stop.
Feet Down
Press and hold to raise the backrest, release the button to stop .
Back Up
Press and hold to lower the backrest, release the button to stop.
Back Down
Power on/off
Power Cord
Power Box
Grounded Wall Outlet
.