User's Manual

Armrest linkage unit

Bracket 4

Bracket 2

Bracket 1

Bracket 3

Screw hole

Armrest unit

Screw nut

Air hose

Air nozzle

Footrest drive wire

plug connector

Footrest drive wire socket connector

Hold the armrest unit up and hook the bracket 2 onto the carrier groove,slowly push

the armrest unit back into the chair linkage until bracket 2 aligns completely with

bracket 4,insert bracket 1 into bracket 3,use a screw to secure the armrest into place.

(Same installation method with the other side)

Insert the lower end of Touchscreen Controller holder into the socket,turn the nut

clockwise to secure the holder into place; fit touchscreen controller wire plug into

the drive wire socket by the seat side,make sure they are well secured.

Raise the legrest unit,thread the air hose into the air nozzle,and fit the air valve plug

into the air valve port which located at the face side of seat base,make sure they are

well secured.

Step 3: Install Touchscreen Controller Holder

Step 4, Install the Footrest Unit

PRELIMINARY CHECKS