User's Manual
Table Of Contents
- 一、Functions and features
- 三、Development and debugging
- 3.3.2 Burning steps
- 1) Before burning the picture font library, make sure that the bottom layer has been burned. You can open the configuration debugging interface to connect to the code file to observe whether it can communicate. If it fails to communicate, first reset ...
- 2) After adding the files to be burned in the U disk according to the second step, connect it to the USB port of the motherboard, and then power on the motherboard.
- 3) Under normal circumstances, the display screen will start to flash and display burned pictures after a few seconds, and the U disk indicator light will start to flash.
- 4) If you cannot see the burning process, please make sure to unplug the U disk under the premise that the U disk indicator is not flashing.
- 四、Description of environmental indicators
- 五、Connect with external controller
- 空白页面
1、Functions and features
1. Integration of control, display and communication
Display: Exquisite and practical industrial-grade TFT LCD screen, which can realize the
display of various components
Control: 5 channels of switch input, 6 channels of switch/PWM output, 8 channels of analog
input, 1 channel of motor drive output
Communication: support a variety of wired and wireless communication technologies,
compatible with J1939/CANOpen/CAN2.0B protocol; support USB program and quick download
of pictures
The function overview is as follows：
Numbering
Features
Sub-number
Subfunction
description
1 display
1.1 Picture switch Press the button to turn the page
1.2 Variable display
Display variable value at specified
position
1.3 Icon display
Display a customized icon in the
specified location
1.4 Bar graph display
The progress bar shows the associated
variable value
1.5 Cut picture
Cut the picture to a custom target
location
2 communication
2.1 CAN communication
Receive the CAN data of the Huaxing
controller and send it to the
configuration software after
processing; receive the data of the
configuration software and send it to
the controller；
2.2
LTE communication,
GPS communication
Upload data to the remote monitoring
center; receive data from the
monitoring center; receive satellite
latitude and longitude information
2.4
GPRS remote debugging
and update of LM
configuration
The remote technical support center can
perform remote LM debugging and
brushing
2.5
USB update program
and pictures
After plugging in the USB with HMI
configuration, the configuration and picture
will be updated automatically after power on
1