User's Manual
Table Of Contents
- 一、Functions and features
- 三、Development and debugging
- 3.3.2 Burning steps
- 1) Before burning the picture font library, make sure that the bottom layer has been burned. You can open the configuration debugging interface to connect to the code file to observe whether it can communicate. If it fails to communicate, first reset ...
- 2) After adding the files to be burned in the U disk according to the second step, connect it to the USB port of the motherboard, and then power on the motherboard.
- 3) Under normal circumstances, the display screen will start to flash and display burned pictures after a few seconds, and the U disk indicator light will start to flash.
- 4) If you cannot see the burning process, please make sure to unplug the U disk under the premise that the U disk indicator is not flashing.
- 四、Description of environmental indicators
- 五、Connect with external controller
- 空白页面
1-4.3 horizontal screen;
2---5.0 vertical screen
3—7.0 Portrait
After the first line is over, press Enter, and write GUILib: V. in the second line.
After the second line is over, press Enter to save and exit.
3）Create three folders, ICON, LIB, and PHOTO under the GUI folder
LIB folder---used to place font files, the naming of font files conforms to XXXX.DZK (X is Arabic
numerals)
PHOTO folder---used to store picture files, the pictures are converted from the host computer
download tool, and the name conforms to XXXX.bmp (X is Arabic numerals)
ICON folder---used to place icon files