User's Manual

滚滚长江东逝水
Shanghai Qiangling Electronics Co., Ltd.
All rights reserved, contents or specifications are subject to change without prior notice.
11
8.7 Label and compliance information
The outside of final products that contains this module device must display a label referring to the enclosed
module. This exterior label can use wording such as: “Contains Transmitter Module FCC ID: NIR-WIFI8711 ”,or
“Contains FCC ID: NIR-WIFI8711”, Any similar wording that expresses the same meaning may be used.
8.8 Information on test modes and additional testing requirements
a) The modular transmitter has been fully tested by the m
odule grantee on the required number of channels,
modulation types, and modes, it should not be necessary for the host installer to re-test all the available transmitter
modes or settings. It is recommended that the host product manufacturer, installing the modular transmitter, perform
some investigative measurements to confirm that the resulting composite system does not exceed the spurious
emissions limits or band edge limits (e.g., where a different antenna may be causing additional emissions).
b) The testing should check for emissions that may occur due to the intermixing of emissions with the other
transmitters, digital circuitry, or due to physical properties of the host product (enclosure). This investigation is
especially important when integrating multiple modular transmitters where the certification is based on test
ing each
of them in a stand-alone configuration. It is important to note that host product manufacturers should not assume that
because the modular transmitter is certified that they do not
have any responsibility for final product compliance.
c) If the investigation indicates a compliance concern the host product manufacturer is obligated to mitigate the
issue. Host products using a modular transmitter are subject to all the applicable individual
technical rules as well as
to the general conditions of oper
ation in Sections 15.5, 15.15, and 15.29 to not cause interference. The operator of
the host product will be obligated to stop operating the device until the interference has been corrected
Below are steps for on test modes
For
the convenience of customers to test and debug Ameba Series IC, we offer our customers a windows- based
system UI_mptool; The tool contains four sub-interface Main, PSD, Efuse, Reg.
Oper
ation steps:
1. Open“Setup/ Realtek_DUT_Selection.exe",and set every item according to the picture below, Module
RF
Mode
Software Control Interface setup Items are particularly important.
Note
Module for Ameba1 8195AM/8711AM/8711AF ,Please select “ RTL81 XXE Series ” For
AmebaZ(8710BN/8711BN/8711BG),Please select“ RTL871XB Series”.