User's Manual

01. Make sure your remote control is in range of the light

bulb you are removing. Remove the battery cover from the

back of the remote control so that you have access to the

Program button.

02. Make sure power to the ﬁxtures containing the light bulbs

you want to remove is turned ON. If there are other light

bulbs on the network that are assigned to the same lighting

group, but you do NOT want to remove those light bulbs

from the network, then turn power to those light ﬁxtures OFF

(you can turn them back on after you have ﬁnished remov-

ing light bulbs). If you do not turn the other light bulbs off,

then they will also be removed from the network since the

action applies to the entire lighting group. If you acciden-

tally remove a light bulb from the network, you can simply

add it back again using the procedure in this chapter for

adding light bulbs to the network.

03. On the remote control:

a. Press and hold the Program button.

b. While pressing the Program button, press and release

the ON/OFF button (keep the Program button pressed).

c. While still pressing the Program button, press and

release the Group Number button for the lighting group

assigned to the light bulbs you want to remove; or, if you

are removing light bulbs from ALL lighting groups, press

and release the 1-4 button (keep the Program button

pressed, regardless of the group button you press).

d. While still pressing the Program button, press and

release the ON/OFF button again.

e. Release the Program button. The group number indicator