User's Manual

20
1. Reset Existing Network Light Bulbs, if Any
If you are not upgrading from a remote control lighting kit, you can skip this step. If you are upgrading
from a remote control lighting kit, then you must reset all light bulbs that you previously installed as part of that
kit’s setup. The easiest way to reset all light bulbs is to do so using the following procedure.
1. Turn the main switch ON for two seconds.
2. Turn the main switch OFF for two seconds.
3. Repeat steps 2 and 3 for two more times.
4. Turn ON the switch after the last try so that the bulb remains ON.
5. Notice that the bulbs start to dim and brighten indicating that they have been reset and have been
removed from their association with the Remote Control they were paired to.
When the light bulbs have been removed from the network, they will brighten and dim, at which time you can add
them to your new network.
After resetting the light bulbs, the Remote Control also needs to be reset to its factory default conditions. This is
the Remote Control that came with the kit you are upgrading.
1. Remove the battery cover from the back of the original remote control so you have access to the
Program button.
2. On the remote control:
a. Press and hold the Program button.