User's Manual

64
Once this process is complete, you can use the remote control as discussed in the rest of this chapter.
Connecting a New or Pre-existing Remote Control to the Gateway
The remote control in your lighting kit is already connected to your Gateway by default, so it is ready to use after
you prepare it as discussed above. However, there are a few situations in which you would have to manually
connect a remote control to your Gateway:
• If you are adding a new remote control to your network
• If you are upgrading your lighting network from a remote control kit and would like to use the old
remote control with your new network
• If you performed a factory reset on your remote control and need to re-connect it to the Gateway
• If you changed your Gateway and need to connect your pre-existing remote control to the new
Gateway
If you are upgrading your lighting network from a remote control kit (meaning you didn’t have a Gateway before),
you don’t need to factory reset your remote control and you can start from step 1 below.
However, if your remote control has been commissioned to another Gateway previously, you need to factory
reset your remote control before connecting it to your new Gateway (Please refer to Resetting the Remote
Control section).
To physically connect a new or factory reset remote control to the Gateway: