User's Manual
PropertyofTCPInc
ProprietaryandConfidential
测试条件：装有电池的情况下
4) It's acceptable that recover the
separation between upper and bottom
panels except crack.
允许复合上下面板，但是不能有裂损
KFR‐600 Keypad/ButtonLifeTest
1) Test times: 20,000 times with metal dome
测试次数：用金属圆顶 20,000 次
4
1) The function of key components
should be normal after the test.
Y(T1)
按键寿命测试
2) Force: 200gf
力度：200gf
测试后，关键元器件功能正常
3) Frequency: 4.8Hz
频率：4.8Hz
4) Test Sample Status: Power-off
测试样品状态：断电源
KFR‐610 BatteryLifeTest
a) Measure current/voltage of the tested unit when
1)Batteries just installed and 2) The 5 LEDs turn ON
before the test.
测量电流/电压当 1）电池刚刚插入 和 2）5 个 LED 指
示灯全亮
1 (T2)
电池寿命测试
b) Using the group button “1-4” on the remote to pair
with a light-bulb.
用遥控器上全组键“1-4”
c) After pairing, select the group button then press the
on/off button. You should see the light-bulb turn on
and off as well.
d) Start the battery life test by pressing the on/off
button at 9 sec interval, monitor voltage and check
LED/light-bulb on/off until battery die.
KFR‐700 PrintedMaterialStrength
Test
1) Test times: 100 times (1 time= from one side to the
other )
4
1) No sign of peeling shall be appeared.
T1/T2‐PASS,T3‐FAIL
2) Liquor: Alcohol 95%
3) Pressure: 500g/cm
2
at less
KFR‐900 SaltSprayTest
1)喷雾液：5%NaClPH=6
4 >2HNoSignofcorrosiontometal Y(T1)
2）实验室温度 35饱和空气桶温度 47
3）喷雾量：1.3ml/80cm
2
/H
KFR‐1000 BatteryDoorTest
电池盖拆装测试
Openandclose50times
拆装电池盖 50 次
4 BatteryDoorshouldbeabletofunction
normallywithoutbecomingloose
电池盖功能正常，无松动。
Y(T3)
EffectiveRFrange
1)Atleast70m(lineofsight)withoutRangeExtender
(PA),bulbat1mheight,remote1.0‐1.2m
RFrange>75m Y(T1)