Data Sheet
Table Of Contents
- Abstract
- 1. Introduction
- 2. Characteristics
- 3. Pin Definition
- 4. System memory Space
- 5. ATE（RF Test Mode）
- 5.1. Wi-Fi ATE Command
- 5.1.1. Start MP mode
- 5.1.2. Stop MP mode
- 5.1.3. Set Tx rate
- 5.1.4. Set operational channel
- 5.1.5. Set operational bandwidth
- 5.1.6. Set Tx power
- 5.1.7. Set antenna for Tx
- 5.1.8. Set antenna for Rx
- 5.1.9. Start air Rx mode
- 5.1.10. Start continuous Tx mode
- 5.1.11. Query air Rx statistics
- 5.1.12. Reset air Tx/Rx statistics
- 5.2. Bluetooth ATE Command（TBD）
- 5.3. Example Command
- 5.1. Wi-Fi ATE Command
- 6. Flash Programming
- 7. Electrical Parameters
- 8. RF Parameter
- 9. Antenna Information
- 10. Dimensions and Production Guidance
- 11. Production Guidelines
- 12. FCC and IC Information
- 12.1. FCC Warning
- 12.2. IC warning
- 12.3. Trace antenna designs
- 12.4. RF exposure considerations
- 12.5. Antennas
- 12.6. Label and compliance information
- 12.7. Information on test modes and additional testing requirements5
- 12.8. Additional testing, Part 15 Subpart B disclaimer
- 12.9. The module is limited to OEM installation ONLY.
- 12.10. The OEM integrator is responsible for ensuring that the end-user has no manual instructions to remove or install module.
- 12.11. The module is limited to installation in mobile or fixed applications
- 13. Packaging and Label Information
- 14. Sales and Technical Support Information
EMC3380 Series Wireless Module Data Manual
Copyright of Shanghai MXCHIP Information Technology Co., Ltd.
3
8.2.3. IEEE802.11n-HT20(2.4G) mode ......................................................................................................... 37
8.2.4. EMC3380 Bluetooth RF characteristic ............................................................................................... 41
Antenna Information .............................................................................................................................. 43
Antenna Type .............................................................................................................................. 43
PCB Antenna Clearance .............................................................................................................. 43
External Antenna Connector ...................................................................................................... 44
Dimensions and Production Guidance ................................................................................................. 45
Assembly Dimension Diagram .................................................................................................... 45
Packing dimension diagram ........................................................................................................ 45
Production Guidelines ........................................................................................................................ 46
Precautions ................................................................................................................................. 47
Storage Condition ....................................................................................................................... 48
Secondary Reflux Temperature Curve ........................................................................................ 48
FCC and IC Information ....................................................................................................................... 50
FCC Warning ............................................................................................................................... 50
IC warning ................................................................................................................................... 50
Trace antenna designs ................................................................................................................ 51
RF exposure considerations ........................................................................................................ 51
Antennas ..................................................................................................................................... 52
Label and compliance information ............................................................................................. 52
Information on test modes and additional testing requirements5 ............................................ 52
Additional testing, Part 15 Subpart B disclaimer ........................................................................ 53
The module is limited to OEM installation ONLY. ....................................................................... 53
The OEM integrator is responsible for ensuring that the end-user has no manual instructions
to remove or install module. ........................................................................................................................... 53
The module is limited to installation in mobile or fixed applications ..................................... 53
Packaging and Label Information......................................................................................................... 54
packaging information ................................................................................................................ 54
Label Information ....................................................................................................................... 54