Data Sheet
Table Of Contents
- Abstract
- 1. Introduction
- 2. Characteristics
- 3. Pin Definition
- 4. System memory Space
- 5. ATE（RF Test Mode）
- 5.1. Wi-Fi ATE Command
- 5.1.1. Start MP mode
- 5.1.2. Stop MP mode
- 5.1.3. Set Tx rate
- 5.1.4. Set operational channel
- 5.1.5. Set operational bandwidth
- 5.1.6. Set Tx power
- 5.1.7. Set antenna for Tx
- 5.1.8. Set antenna for Rx
- 5.1.9. Start air Rx mode
- 5.1.10. Start continuous Tx mode
- 5.1.11. Query air Rx statistics
- 5.1.12. Reset air Tx/Rx statistics
- 5.2. Bluetooth ATE Command（TBD）
- 5.3. Example Command
- 5.1. Wi-Fi ATE Command
- 6. Flash Programming
- 7. Electrical Parameters
- 8. RF Parameter
- 9. Antenna Information
- 10. Dimensions and Production Guidance
- 11. Production Guidelines
- 12. FCC and IC Information
- 12.1. FCC Warning
- 12.2. IC warning
- 12.3. Trace antenna designs
- 12.4. RF exposure considerations
- 12.5. Antennas
- 12.6. Label and compliance information
- 12.7. Information on test modes and additional testing requirements5
- 12.8. Additional testing, Part 15 Subpart B disclaimer
- 12.9. The module is limited to OEM installation ONLY.
- 12.10. The OEM integrator is responsible for ensuring that the end-user has no manual instructions to remove or install module.
- 12.11. The module is limited to installation in mobile or fixed applications
- 13. Packaging and Label Information
- 14. Sales and Technical Support Information
EMC3380 Series Wireless Module Data Manual
Copyright of Shanghai MXCHIP Information Technology Co., Ltd.
29
mxos make helloworld@emc3380 download
Command results:
Making config file for first time
processing components: helloworld emc3380 MXOS
……
Downloading applcation, size: 443512 bytes...
############################################################################################################
######################################################################################################## 100%
433 KiB 8.0 KiB/s 18 s
Build complete
Making .gdbinit
Making .openocd_cfg
If the pre-burned bootloader in the module is damaged, simply add the total parameter to the
command to re-burn the bootloader.
mxos make helloworld@emc3380 total download
Burn using serial download mode
1. Connect the hardware according to Figure 6. After PA7 is grounded, power on or reset the module. Then
release PA7 to enter serial port download mode.
Figure 6 Serial download mode connection diagram
If you use the MXKIT series evaluation board provided by MXCHIP, the BOOT0 signal on the Arduino
interface on the MXKIT-BASE board is grounded. After resetting, remove the ground.