Data Sheet
Table Of Contents
- Abstract
- 1. Introduction
- 2. Characteristics
- 3. Pin Definition
- 4. System memory Space
- 5. ATE（RF Test Mode）
- 5.1. Wi-Fi ATE Command
- 5.1.1. Start MP mode
- 5.1.2. Stop MP mode
- 5.1.3. Set Tx rate
- 5.1.4. Set operational channel
- 5.1.5. Set operational bandwidth
- 5.1.6. Set Tx power
- 5.1.7. Set antenna for Tx
- 5.1.8. Set antenna for Rx
- 5.1.9. Start air Rx mode
- 5.1.10. Start continuous Tx mode
- 5.1.11. Query air Rx statistics
- 5.1.12. Reset air Tx/Rx statistics
- 5.2. Bluetooth ATE Command（TBD）
- 5.3. Example Command
- 5.1. Wi-Fi ATE Command
- 6. Flash Programming
- 7. Electrical Parameters
- 8. RF Parameter
- 9. Antenna Information
- 10. Dimensions and Production Guidance
- 11. Production Guidelines
- 12. FCC and IC Information
- 12.1. FCC Warning
- 12.2. IC warning
- 12.3. Trace antenna designs
- 12.4. RF exposure considerations
- 12.5. Antennas
- 12.6. Label and compliance information
- 12.7. Information on test modes and additional testing requirements5
- 12.8. Additional testing, Part 15 Subpart B disclaimer
- 12.9. The module is limited to OEM installation ONLY.
- 12.10. The OEM integrator is responsible for ensuring that the end-user has no manual instructions to remove or install module.
- 12.11. The module is limited to installation in mobile or fixed applications
- 13. Packaging and Label Information
- 14. Sales and Technical Support Information
EMC3380 Series Wireless Module Data Manual
Copyright of Shanghai MXCHIP Information Technology Co., Ltd.
23
ATE（RF Test Mode）
According to the Table 5 firmware special function capture pin, after the module is started into the
ATE mode, it can interact with the module through the debug serial port (UART_LOG) to make the
module enter a specific transmit and receive mode, thereby carry out testing the RF and electrical
performance.
Figure 4 The Schematic Diagram of ATE Mode Connection
If the MXKIT series evaluation board provided by MXCHIP is used, the BOOT signal on the DIP
switch on the MXKIT-BASE board can be turned to the ON side.
PC serial terminal setting parameters: 115200 baud rate, 8 data bits, 1 stop bit, no parity. The
following ATE commands are supported:
Wi-Fi ATE Command
5.1.1. Start MP mode
After executing this command, the Wi-Fi driver stops transmitting data and enters MP mode.
iwpriv mp_start
5.1.2. Stop MP mode
After executing this command, the Wi-Fi driver stops the packet transmission started by other commands.
But the system needs to be restarted , and it can enter the normal Wi-Fi connection mode.
iwpriv mp_stop
5.1.3. Set Tx rate
Set the data transmission rate of Tx messages.
iwpriv mp_rate rate
rate: data transmission rate，2 = 1M, 4 = 2M, 11 = 5.5M, …, 108 = 54M, 128 = MCS0, 129 = MCS1, …,
142 = MCS15
5.1.4. Set operational channel
Set the working frequency band of sending and receiving packets.
iwpriv mp_channel channel