Data Sheet
Table Of Contents
- Abstract
- 1. Introduction
- 2. Characteristics
- 3. Pin Definition
- 4. System memory Space
- 5. ATE（RF Test Mode）
- 5.1. Wi-Fi ATE Command
- 5.1.1. Start MP mode
- 5.1.2. Stop MP mode
- 5.1.3. Set Tx rate
- 5.1.4. Set operational channel
- 5.1.5. Set operational bandwidth
- 5.1.6. Set Tx power
- 5.1.7. Set antenna for Tx
- 5.1.8. Set antenna for Rx
- 5.1.9. Start air Rx mode
- 5.1.10. Start continuous Tx mode
- 5.1.11. Query air Rx statistics
- 5.1.12. Reset air Tx/Rx statistics
- 5.2. Bluetooth ATE Command（TBD）
- 5.3. Example Command
- 5.1. Wi-Fi ATE Command
- 6. Flash Programming
- 7. Electrical Parameters
- 8. RF Parameter
- 9. Antenna Information
- 10. Dimensions and Production Guidance
- 11. Production Guidelines
- 12. FCC and IC Information
- 12.1. FCC Warning
- 12.2. IC warning
- 12.3. Trace antenna designs
- 12.4. RF exposure considerations
- 12.5. Antennas
- 12.6. Label and compliance information
- 12.7. Information on test modes and additional testing requirements5
- 12.8. Additional testing, Part 15 Subpart B disclaimer
- 12.9. The module is limited to OEM installation ONLY.
- 12.10. The OEM integrator is responsible for ensuring that the end-user has no manual instructions to remove or install module.
- 12.11. The module is limited to installation in mobile or fixed applications
- 13. Packaging and Label Information
- 14. Sales and Technical Support Information
EMC3380 Series Wireless Module Data Manual
Copyright of Shanghai MXCHIP Information Technology Co., Ltd.
9
▪ LP-GDMA0 supports 6 channels
Flash
▪ SPI Flash controller with cache
▪ Support ICP technology, directly program Flash
General-Purpose I / O (GPIO)
▪ 16 GPIOs with configurable pull-up and pull-down resistors
▪ Configurable external interrupt triggered by rising edge, falling edge and both edges
Wireless Communication
Wi-Fi
▪ 802.11 b / g / n 1x1, 2.4GHz & 5GHz
▪ Support 20MHz / 40MHz bandwidth, 802.11n rate reaches MCS7
▪ Low-power architecture, support low-power transmission and reception for short-range applications, low-
power beacon monitoring mode, low-power RX mode, low-power suspend mode (DLPS)
▪ Support external power amplifier
BT BLE
▪ Support Bluetooth low energy
▪ Supports both master and slave modes
▪ High power mode (10dBm, sharing PA with Wi-Fi)
▪ Built-in Wi-Fi / Bluetooth single antenna coexistence mechanism
Security
▪ AES / DES / SHA hardware encryption algorithm engine
▪ Support TrustZone-M technology
▪ Support Secure boot
▪ SWD debug interface protection to prevent debug interface from accessing protected and prohibited areas
▪ Support RSIP, Flash data decryption
Communication Interface
USB
▪ Support USB 2.0, support high speed / full speed / low speed mode
▪ Support DMA transfer, 1.5Kbyte input block buffer, 1.5Kbyte output block buffer
SPI
▪ Support Motorola SPI serial data transmission
▪ Support master-slave mode