Specifications

L506 Hardware Design

FCC Caution:

(1)Exposure to Radio Frequency Radiation. This equipment must be installed and

operated in accordance with provided instructions and the antenna(s) used for this

transmitter must be installed to provide a separation distance of at least 20 cm from all

persons and must not be collocated or operating in conjunction with any other antenna or

transmitter. End-users and installers must be provided with antenna installation

instructions and transmitter operating conditions for satisfying RF exposure compliance.

(2) Any changes or modifications not expressly approved by the grantee of this device

could void the user's authority to operate the equipment.

(3) This Transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

(4) Labelling requirements:This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

(5) if the host is marketed so that end users do not have straight forward commonly used

methods for access to remove the module so that the FCC ID of the module is visible;

then an additional permanent label referring to the enclosed module: Contains Transmitter

Module FCC ID: 2AK9DL506LA1or Contains FCC ID: 2AK9DL506LA1 must be used.

This product is suitable for collocation single-stage sub-antenna.

Gain the scope of the reference is as follows: