User's Manual

WARNING
Connector Connection
Insert the receiver, servo, and battery
connectors fully and firmly.
If vibration, etc. causes a connector to work
loose during running, the car may crash.
Servo Throw
Servo Installation
Install the servo to the servo mount,
etc. through a rubber grommet. Also
install the servo so that the servo
casedoes not directly touch the servo
mount or other parts of the chassis.
SCREW
GROMMET
BRASS EYELET
(Servo mount)
Receiver Vibration proofing
/ Waterproofing
<Antenna installation>
. .
Receiver Antenna
Do not cut or bundle the receiver
antenna. Also, do not bundle the
antenna together with the servo
lead wires. . .
Cutting or bundling the receiver antenna will
lower the receiver sensitivity and shorten
the flight range and cause a crash. ..
Operate the servo horn over its full
stroke and adjust so that the pushrod
does not bind or is not too loose. ..
Unreasonable force applied to the servo horn
will adversely affect the servo and drain the
battery quickly. ..
Vibrationproof the receiver by wrapping
it in sponge rubber or some such
material. If the receiver may get wet,
waterproof it by placing it in a plastic
bag.
If the receiver is subjected to strong vibra-
tion and shock, or gets wet, it may operate
erroneously and cause a crash.
Use a rubber grommet, etc. at the part at
which the antenna comes out of the body
through the antenna tube so that it will not
break. . .
RR
7