User's Manual

Adjustment And Installation
This section describes the installation method and adjustment method after installation when installing
the receiver, servo, ESC to the car.
Connections
Connection example is shown below.
Connection Example
LED
* The number of servos depends
on the set.
Receiver
RR
6
Receiver
ESC
1. There is “Power Down Mode” build in for doing a ground range check to activate the “Power Down
Mode” by pressing the “PDM” button transmitter. The Green LED will turn off to indicate the PDM is
working. During this mode, the RF power is reduced so the range test can be performed.
2. Walk away from the car while simultaneously operating the controls. Have an assistant stand by the
model and signal what the controls are doing to confirm that they operate correctly. You should be
able to walk 30-50 paces approximately from the model without losing control.
3. If everything operates correctly, return to the car. The “Power Down Mode” continues for 60 seconds
and after that the power will go back to the normal level. To exit the “Power Down Mode” before the
60 seconds, press the “PDM” key again.
4. Never start flying when the “Power Down Mode” is active.
.
.
.
.
.
.