User's Manual

The transmitter has a individual randomize ID that is created in the factory,
Even it is
almost have no chance to meet the same ID transmitter in the same
fly field,
he transmitter has an ID set up function.
You can go back to the original factory set ID by h
in case it does
happen. T
olding the “PDM” when
turn on the
transmitter, without press the “PDM” bottom, turn it off and on
again to get back the
original ID.
Change the transmitter ID
Range check the radio
A range check must be performed before the first flight of a new model. It is
not necessary
to do a range check before every flight (but is not a bad idea to
perform a range check
before the first flight of each day). A range check is
the final opportunity to reveal any
radio malfunctions, and to be certain the
system has adequate operational range.
1. There is "Power Down Mode" build in for doing a ground range check
To activate the
"Power Down Mode" by pressing the “PDM” button
on the right upper panel of the
transmitter. The Green LED will turn
off to indicate the PDM is working. During this
mode, the RF power is
reduced so the range test can be performed.
2. Walk away from the model while simultaneously operating the controls.
Have an
assistant stand by the model and signal what the controls are
doing to confirm that
they operate correctly. You should be able to walk
30 - 50 paces approximately from
the model without losing control.
3. If everything operates correctly, return to the model. The "Power Down
Mode"
continues for 60 seconds and after that the power will go back to
the normal level.
To exit the "Power Down Mode" before the 60 seconds,
press the "PDM" key again.
4. NEVER start flying when the "Power Down Mode" is active.