User's Manual

Fail Safe Setup , Continue...
4. To confirm that fail safe is working properly, the ESC will go in to the neutral
position and the vehicle will not move when you shut off the transmitter. See
page 5 and check the Fail Safe function working properly. You do not need to
repeat this procedure each time you run.
5. To confirm that fail safe is working properly, full brake should automatically be
applied when you shut off the transmitter. See page 5 and check the Fail Safe
function working properly. You do not need to repeat this procedure each time
you run.
Turn off receiver first, then turn off transmitter.
Binding Setup
Fail Safe Setup
Programming a receiver to recognize the code of only one specitic transmitter.
The fail safe system has been setup at the factory,but you should become
familiar with the function of the fail safe and check the operation before
running. When fail safe is operating,the red LED will continuously flash.
1. Place the transmitter and the receiver close to each other (within one meter).
Turn the power switch on the transmitter to the ON position.
2. Press and hold the receiver setup button,then turn the power switch to the ON
position. The receiver LED will flash quickly. Release the setup button after
1 second.
3. Press and hold the binding button on the transmitter for 1 second until the
LED on the receiver is continuously lit.
1. Turn the power switch to the ON position on the transmitter. Press the setup
button on the receiver then release. LED will flash.
2. Leave throttle trigger in neutral position, and press the setup button. The LED
will flash quickly.Once the receiver LED remains lit, then release the setup
button on the receiver.
3. Hold full brake on the transmitter, and press the setup button. The LED will
flash quickly. Release full brake on the transmitter once the receiver LED
remains lit, then release the setup button on the receiver.
If you change transmitters or add a receiver, you must re-bind
before operating your vehicle.
The fail safe can not completely protect your car.
Any new binding of transmitter & receiver will clear the preset
fail safe.