User's Manual

Transmitter antenna
1. The transmitter antenna is adjustable
so
please make sure that the antenna is
never pointed directly at the model
when flying as this creates a weak signal
for the receiver.
2. Keep the antenna perpendicular to the
transmitter's face to create a better RF
condition for the receiver. Of course
this depends on how you hold the
transmitter, but in most cases, adjusting
the transmitter antenna so that it is perpendicular to the face will give the best
results. Please adjust the transmitter antenna to the way you hold the
transmitter.
3. NEVER grip the antenna when flying as this degrades RF quality.
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the operating instructions,
may cause harmful interference to radio communications, however, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced technician for help.
This device complies with Part 15 of the FCC Rules and with RSS-210 of
Industry Canada.Operation is subject to the following two conditions:
1)This device may not cause harmful interference, and....
2)This device must accept any interference received, including interference that
may cause undesired operation.
WARNING:Changes or modifications made to this equipment not expressly
approved by the party responsible for compliance may void the FCC authorization
to operate this equipment.