Product Manual

Product Manual-Automobile Tire Pressure Monitoring System
1、Product summary
TPMS is Tire Pressure Monitoring System. Main function is to monitor, display and confirmed
the working state of the tyre, and the tyres appear abnormal conditions (such as
overpressure, undervoltage, over temperature, atmospheric pressure mutations, etc.) in
time report to the police, and through the light and sound, digital display the current
situation, in order to ensure safety, prevent blowout, at the same time ensure car tyres in
the rational use of state for a long time.
2、Installation and learning process
a. Put the four sensors to tire then according to the normal air flushing pressure values.
b. Press to indicate a streetlight "MENU" button and choose to "fuel mileage information
MENU" inside "tire pressure shows" item, then press the Set/Clr.
c. The driver information center will display "tire pressure to learn", select "yes", press
the Set/Clr button, horn ring 2 times.
d. The driver information center will display "tire pressure learning enabled".
e. Starting from the left front wheel, will reset meter antenna up to resist valve core
location, close to the wheel hub of tire, press tool start switch, a loud beeps when the
speaker says it has read the tire pressure sensor information.
f. According to the above method in turn to the right front - right rear - left rear wheel
speed sensor to perform after reading process, when the learning process is complete,
turn signal launch 3 seconds and two beeps from the horn.
Caution: if more than learning process models are not suitable for owners, please go
to the 4 s shop learn by computer.
3、Relearn judgment
When the tire pressure monitoring failure, Tyre transposition, Replace the body control
module, or replace the tire pressure monitoring sensors, tire pressure need to learn.
4、Disassembling failure tire pressure sensor
Disassembling tools: T10 plum blossom in hexagon wrench or direct replacement valve.
Need to learn tire pressure sensor after disassembling.
5、Installation, inspection and judgment
After installing the new sensor to relearn, if the trouble light is not bright, each tire
pressure values appear on the dashboard said installed correctly.
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.