User's Manual

Declaration of Conformity

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the

equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to

the following two conditions:

(1) This device may not cause harmful interference

(2) This device must accept any interference received, including interference

that may cause undesired operation.

THIS MOBILE PHONE MEETS THE INTERNATIONAL

RECOMMENDATIONS FOR EXPOSURE TO

RADIO WAVES

Your mobile phone is a radio transmitter and receiver. It is designed and

manufactured not to exceed the limits for exposure to radio frequency (RF)

energy defined by the international standards. These recommendations have

been established by the International Commission on Non-Ionizing Radiation

Protection (ICNIRP) and, the Institute of Electrical and Electronics Engineers

(IEEE) that forecast a substantial safety margin for assuring the protection of