Instruction Manual

Table Of Contents
Warning
The product shall only be connected to a USB interface of version USB2.0
Please use common USB Cable or original charger, Otherwise, It may result to danger. When you
use a charger for charging, adapter shall be installed near the equipment and shall be easily
accessible.
Manufacturer of Power Adapter: Shenzhen Mingxin Power Technologies Co., Ltd.
Model: MX24W1-1202000V
Parameters of Power adapter: Input:AC100-240V, 50/60Hz, 0.7A; Output: DC12V/2A
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 20cm must be maintained between
the users body and the handset, including the antenna.
This product can be used across EU member states.
2.4GWi-Fi frequency range: 2412-2472MHz, Maximum E.I.R.P: 16.76dBm
RED 2014/53/EU
Declaration Of Conformity
This product can be used across EU member states .
Hereby, Shanghai IP3 Information Technology CO.,Ltd declares that this Face recognition &
temperature measurement AIO system is in compliance with the essential requirements and
other relevant provisions of directive 2014/53/EU.
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any inte rference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interferenceto radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.