Instruction Manual

13
You may check if it is working normally by gently
tapping the diaphragm of the Stemoscope PRO. If
you can hear the tapping sounds from the
earphones, it is working.
3.2. Second time to connect Bluetooth
earphones
Stemoscope PRO can only store one piece of
pairing information. When a new set of Bluetooth
earphones are connected to Stemoscope PRO, the
pairing information of the old one will be wiped
out. Therefore, if Stemoscope PRO has been
connected to a new set of Bluetooth earphones, it
cannot be connected to the old one automatically.
You need to pair the old Bluetooth earphones with
the Stemoscope PRO again by following the
instructions in Section 3.1. That is, let your
earphones re-enter the pairing state and the
Stemoscope PRO will pair with and connect to
them.