User's Manual
Table Of Contents
Page
7
4.3. T
URNING THE DEVICE ON
/
OFF OR STANDBY
Make sure that the receiver battery is charged OR that the
LT400HS is connected to PC via data cable (internal battery shall
always be installed).
Press the power button for 3-5 seconds to turn on/off the device.
Note: If you need to perform soft reset, use the stylus to press
the Reset key (located beside the power button). This will re-boot
the Windows Mobile operating system. Before operation,
please make sure your task performing has been stored.
4.4. C
ONNECT TO
O
FFICE
C
OMPUTER
To install software or access to the LT400HS, you can use your
office computer and a Microsoft ActiveSync connection to transfer
the installation files from the computer to LT400HS.
It means Microsoft Windows Mobile Device Center or ActiveSync
should first be installed on your computer. You can download this
software for free from the Microsoft website.
Note : choose the ActiveSync version
that is suitable for your computer.
Connect the USB data cable between the LT400HS and a USB port
on your computer.
Turn on LT400HS. Wait the computer to start automatically the
connection through the synchronization software.
Sync icon will appear at the bottom right corner of your computer
screen. Simultaneously a Synchronization Setup Wizard window
will pop up, you can close it to continue by clicking Cancel.
You can click Explore on the Microsoft Sync window to explore the
folders on LT400HS, and exchange data between LT400HS and
your computer.