User's Guide

63
7 Default Setting and Configuration Files
Most of the receiver settings are stored in application files. The default application
file, Default.cfg, is stored permanently in the receiver and contains the factory
default settings for the P5 GNSS reference receiver.
Whenever the receiver is reset to its factory defaults, the current settings (stored in
the current configuration file, copy.cfg) are reset to the values in the default
application file.
The P5 GNSS reference receiver extends the use of configuration files to allow
simplified receiver is setting duplication in multiple receivers. This is sometimes
referred to as receiver cloning and is very useful when preparing a large group of
receivers for a field data collection campaign.
7.1.1 Default Receiver Settings
Function
Factory default values
SV Enable
All SVs enabled
General controls
Elevation mask
PDOP mask
0°
6
LEMO port
Baud rate
Format
Flow control
9600
9-None-1(10-pin)
None
DB9 port
Baud rate
Format
Flow control
9600
3-None-6
None
Log status
OFF
Differential data
OFF
Raw data
OFF
Ephemeris data
OFF
NMEA (GPGGA,
GPGSV)
OFF
Reference
position
Latitude
Longitude
Height
0°0’0.00000000’’
0°0’0.00000000’’
0.000
Antenna
Type
Measure Method
Height
None
Antenna Phase Center
2.0000 (Meter)