User's Manual

Page12

4.2.1 SETTHEDATASTREAMOUTPUT

Run ToolBox software, create and save the application file in the

ConfigurationToolboxsoftware,Selectsettingto‘Appliedimmediately’

or‘Storeinreceiver’

Clickon‘Serial’undertheAvailableselectionboxClickAddtoenable

Serial–Port1SelecttheappropriateBaudRate.

Click on ‘Output’ under the Available selection box  Click Add to

enable Output type selection Select NMEA, Port 1 and appropriate

BaudRate

4.2.2 SETTHECOORDI

NATESYSTEM

OnAvailable selection box  Click coordinate Systemthen

editthelocalcoordinatesystem.