User's Manual

Page 46
X360 GIS Reference Receiver User Guide
– DEFAULT SETTING AND CONFIGURATION FILES
Most of the Receiver settings are stored in application files. The
default application file, Default.cfg, is stored permanently in the
Receiver, and contains the factory default settings for the X360 GIS
Receiver.
Whenever the Receiver is reset to its factory defaults, the current settings
(stored in the current configuration file, copy.cfg) are reset to the values in
the default application file.
The X360 GIS Receiver extends the use of configuration files to allow
simplified Receiver setting duplication in multiple Receivers. This is
sometimes referred to as Receiver cloning and is very useful when
preparing a large group of Receivers for a field data collection campaign.
• DEFAULT RECEIVER SETTINGS
Function
Factory default values
SV Enable
All SVs enabled
General controls
Elevation mask
PDOP mask
0°
6°
Lemo port
Baud rate
Format
Flow control
9600
8-
None-
1
None
Log status
OFF
Differential data
OFF
Raw data
OFF
Ephemeris data
OFF
NMEA (GPGGA,
GPGSV)
OFF
position
Latitud
e
Longit
ude
Height
0°0’0.00000000’’
0°0’0.00000000’’
0.000
Antenna
Type
Measure
Method
Height
CHC Helical GNSS
Antenna 2.0000
(Meter)
Antenna Phase Center
• RESETTING THE RECEIVER TO FACTORY DEFAULTS
Log in the web page of the Receiver tap and unfold the Receiver Reset
menu tap the Receiver Reset submenu click the
button to the right of Back to Default Setting field.