User's Manual

6. Configuring the Receiver: Other Than Keypad and Display
� Page 21
X360 GIS Reference Receiver User Guide
Install the GNSS antenna at the appropriate location (see 4.1.5. Place
the antenna for the guidelines); connect the antenna to the TNC Plug
Socket of X360 via the GNSS Antenna Cable.
1. Power the X360 by external power source (e.g. mains supply) with
Adapter via CHC Data Cable.
 Connect the 10-pin Lemo of CHC Data Cable to COM 1 or COM 2 of
X360.
 Plug the male jack connector of Adapter into the female connector
of CHC Data Cable.
 Connect two leg plugs or three leg plugs of Adapter to the mains
supply.
2. Connect the network cable to the RJ45 jack of X360 to link the X360
with network.
NOTE: Also, the X360 can be powered by external battery via CHC
Data Cable. And the power supply voltage should be controlled
between 12 to 36 V DC.
C H C H e lic al G N SS
A n te nn a
A d a p te r