Use Manual

3. Front panel operation
i70 GNSS Receiver User Guide  Page 22
Mode Rover UHF
 Click Enter button to enter the
second-level menus.
 Indicates the current working mode.
Base Cable
 Click Enter button to enter the
configuration screen of the selected
working mode.
 More operation information, see 3.2.
Configure the working mode.
Base Int. UHF
Base APIS
Base APIS & Cable
Rover APIS
Rover Ntrip/IP
Rover UHF
Cancel
Click Enter button to back to the top-level
menu.
Static Off
 Click Enter button to enter the
second-level menus.
 Indicates the current data logging status:
Static Off or Static On.
Set Off
Click Enter button to change the data logging
status.
Recorded 00:02
Indicates the duration of data logging.
Epoch Intv 1s
 Click Enter button to change the
measurement interval.
 The available options are: 0.2s, 0.5s, 1s,
2s, 5s, 10s, 15s, 30s, and 60s.
Mask Angle 13 Degree
Click Enter button to change the mask degree
from 0 degree to 15 degrees.
Duration time 1440 min
 Click Enter button to enter Duration Time
Setting screen.
 In the Duration Time Setting screen, click
Fn button to move to the character of the
duration time value you want to make
change, and then click Enter button to
change from 0 to 9. After the change has
been done, you can click Fn button to
move to OK field, and then click Enter
button to save the change and back to the
second-level menu; or click Fn button to
move to Cancel field and click Enter
button to cancel the change and back to
the second-level menu.
OK
Click Enter button to save the settings of the
data logging and back to the top-level menu,
and then the settings will take effect.