User's Manual

27
To enable IO option, several combinations can be applied. Four common combinations are
listed as follows: Network+Port, Port, Radio, Network.
Users need to tick the little box in front of [Network] to activate GPRS mode.
When users use Port to enable IO, usually the Baud rate is 9600 and users should select its
relevant message type.
When users choose Auto Base, then the mode is Auto Base. When users choose Not Auto,
then the mode is manual mode and users need to input the coordinates of the base station
or get current single position in order to acquire the reference coordinates of the base. Click
[set] and IO configuration is successful.
After setting the mode to Auto Base, select [GPRS and Internal UHF], set mode of the
base, select APIS for Protocol, input the server’s name, IP, port, then click [Set].