User Manual

Preparation
X90 GNSS – 1.01 Rev A – September 2010
10
 If you must store the batteries, fully charge them before
storing and then recharge them at least every three
months.
Disposing of the Rechargeable Lithium-ion Battery
Discharge the lithium-ion battery before disposing of it. When
disposing of the battery, be sure to do so in an environmentally
sensitive manner. Adhere to any local and national regulation
concerning battery disposal or recycling.
3.3 Parts of the Receiver (Control Panel)
3.3.1 Front Panel View
Power Button
To turn on X90 GNSS, hold the power button press and don’t release
until the power LED lights up.
Switch Button
The function of switch button is to switch X90 GNSS from RTK mode
to static mode. The procedure can be divided into 2 steps.
Step 1: Switching
Hold the switch button press and don’t release until you see the
Record LED off.
Step 2: Check
Press the switch button, if the correction LED turns on, it means the
switching succeed.
CAUTION: When you are doing check, if you press and hold the