GETTING STARTED GUIDE X90 Shanghai HuaCe Navigation Technology Ltd.
Copyright Copyright 2009-2011 HuaCe. © 2010- Shanghai HuaCe Navigation Technology Ltd. All rights reserved. The HuaCe are trademark of Shanghai HuaCe Navigation Technology Limited. All other trademarks are the property of their respective owners- Rev, August, 2010. Trademarks All product and brand names mentioned in this publication are trademarks of their respective holders. Where to Find Information This manual is designed to guide you through the basic X90 procedures.
FCC Statement Federal Communications Commission (FCC) Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation of the device.
Content 1. Introduction .................................................................................................................................. 1 1.1 Technical Assistance ............................................................................................................ 1 1.2 Your Comments ................................................................................................................... 1 2. Overview .......................................................................
Introduction 1. Introduction Technical Assistance ● Your Comments ● Thank you for choosing HuaCe X90 GNSS receiver. This Getting Started Guide is designed to help you rapidly familiarize yourself with your new equipment. Only a selection of the many HuaCe X90 GNSS functions is presented in this guide. 1.1 Technical Assistance If you have a problem and cannot find the information you need in the product documentation, contact your local Dealer.
Overview 2. Overview ● Safety Information ● Features ● Specification 2.1 Safety Information This manual describes HuaCe X90 GNSS Receivers. Before you use your receiver make sure that you have read and understood this publication, as well as safety requirements. 2.1.1 Warning and Cautions An absence of specific alerts does not mean that there are no safety risks involved. A Warning or Caution information is intended to minimize the risk of personal injury and/or damage to the equipment.
Overview 2.2 Features The X90 GNSS receiver provides the following features: Submeter-accuracy, real-time positioning using pseudorange corrections. Automatic OTF initialization while moving Single Lithium-ion rechargeable battery One 10-Pin Lemo port for: o RTCM 2.X input and output o CMR input and output o NMEA outputs One TNC radio antenna connector Internal Memory for data storage 2.
Overview Environment Working Temperature: -30 °C — +65 °C Storage Temperature: -40 °C — +75 °C Humidity: 100% condensation Waterproof and Dustproof: IP67, protected from temporary immersion to depth of 1 meter, floating. Shock and Vibration: Survive from 2 meters drop onto concretes Characteristics Buttons and Display: 2 buttons/4 LED lights I/O: RS232, USB Channel: 24 Channels* *Channel Configuration: 12 L1, 12 L2 P(Y) or L2C Channels X90 GNSS – 1.
Preparation 3. Preparation ● Equipment Description ● Batteries and Power ● Parts of the Receiver (Control Panel) 3.1 Equipment Description The tables below provide an overview of the different items composing the HuaCe X90 GNSS. Depending on the different purchase, you may have some of the listed items. Basic Supply is the standard accessories for each kit. Transportation Cases Option and Accessories Options are depending on different orders requirements.
Preparation Transportation Cases Options Item Picture Transport Case Carry Pouch Metal Transport Case for Poles and Antenna Accessories Options Item Picture Double Bubbles Tribranch with High Adapter Single Bubble Tribranch with Lower Adapter External Power Cable X90 GNSS – 1.
Preparation 3.2 Batteries and Power WARNING-Charge and use the rechargeable Lithium-ion battery only in strict accordance with the instructions. Charging or using the battery in unauthorized equipment may cause an explosion or fire, and result in personal injury and/or equipment damage. To prevent injury or damage: Do not charge or use the battery if it appears to be damaged or leaking. Charge the Lithium-ion battery only in HuaCe products that is specified to charge it.
Preparation To prevent injury or damage: If the battery leaks, avoid with the battery fluid. If battery fluid gets into your eyes, immediately rinses your eyes with clean water and seek medical attention. Please do not rub your eyes! If battery fluid gets onto your skin or clothing, immediately use clean water to wash off the battery fluid. 3.2.1 External Power and Internal Battery The receiver can be powered by its internal battery or by an external power source connected to Receiver Lemo Port.
Preparation 3.2.2 Charging the Battery The receiver is supplied with two rechargeable Lithium-ion batteries, and a dual battery charger for each RTK kit. The two batteries charge sequentially and take approximately three hours each to be fully charged. The battery charger comes with a separate universal AC Power Adapter with a 1.5 meter output cable. Follow the instructions below to operate the charger. Connect the two parts of the Power Adapter and the Power Adapter output with the Battery Charger.
Preparation If you must store the batteries, fully charge them before storing and then recharge them at least every three months. Disposing of the Rechargeable Lithium-ion Battery Discharge the lithium-ion battery before disposing of it. When disposing of the battery, be sure to do so in an environmentally sensitive manner. Adhere to any local and national regulation concerning battery disposal or recycling. 3.3 Parts of the Receiver (Control Panel) 3.3.
Preparation switch button again, it will be back to RTK mode. Power LED This indicator is on when X90 GNSS is on, and off when it is off. Satellite LED This LED indicates how many satellites the receiver is tracking on, if the LED flashes 5 times and then stops, it means the receiver is tracking 5 satellites. Record LED The record LED only flashes in 2 situations A. In the static mode The interval of flashing shows the sample interval you set in the HC-Loader or HCGPSet. B.
Preparation Do not expose the battery to fire, high temperature, or direct sunlight. Do not immerse the battery in water. Do not use or store the battery inside a vehicle under hot weather condition. Do not drop or puncture the battery. Do not open the battery or short-circuit its contacts. X90 GNSS – 1.
Setting up the Receiver 4. Setting up the Receiver 4.1Receiver Setup Prerequisites: You need a tripod and a tribrach to install the base. ● To power the radio, you need a standard 12-V DC battery. ● Mount the different items as shown on the picture. X90 GNSS – 1.
Appendix 5. Configuration ● Static Configuration ● RTK Configuration 5.1 Static Configuration There are 3 ways to configure the receiver in Static Mode. A. Using RS232 Port and HCLoader Software in the Office First, connect X90GNSS to your computer through RS232 line. Second, run the software HCLoader and click icon Link to make the receiver connected with computer.
