User's Manual

Control by Phone Call
This feature is available only after having enabled it from the control panel, as explained on page 12
of this manual.
Method 1
When an alarm has been triggered, the control panel dials the stored phone numbers. When you
pick up the phone, follow the voice instructions to control the panel from distance (refer to the
instructions in the table below).
Method 2
1. Dial the telephone number of your control panel (either the number of the SIM card in your
control panel or the number of the landline to which your panel is connected). After getting
through, the voice instructions will guide you to enter your access code.
2. Enter your access code (user code), followed by ”#”.
3. A voice gives you the options you can select.
4. Select the operations to control the panel (see instructions in the table below).
Note
The call will end automatically if you do not send any command within 30 seconds.
Table of commands for control by phone call
Command Function Comment
Press “1“ Arms the system Voice prompt “System armed”
Press “0“ Disarms the system Voice prompt “System disarmed”
Press “
“ Audio monitoring Press “ ” to extend the monitoring time
Press “3“ Phone call with control panel -
Press “6“ Turns the siren o -
Press “9“ Turns the siren on -
Press “#“ Exits control by phone call Hanging up also exits the control by phone call.
Note
In GSM mode, the audio monitoring is not limited in time.
In PSTN mode (connected to your landline), the audio monitoring is limited to 80 seconds. If you
wish to extend the time of audio monitoring, press the “
” on your phone before the end of the
80 seconds.
16