User's Manual

The product under test is placed into a normal ‘paired' mode with another BLE
device，
as per the normal intended use of the product (for example，
transferring data).
W
hen testing for emissions from the unintentional radiator
， the transmitter shall
be placed in t
he receive mode or idle mode， if possible. If receive mode only is
not possible then， the radio shall be passive (preferred) and/or active scanning.
In these cases ， this would need to enable activity on the communication BUS
(i.e.， PCIe， SDIO， USB) to ensure the unintentional radiator circuitry is
enabled. Testing laboratories may need to add attenuation or filters depending
on the signal strength of any active beacons (if applicable) from the enabled
radio(s). See ANSI C63.4， ANSI C63.10 and ANSI C63.26 for further general
testing details.
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada
licence‐exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio
exempts de licenc
e. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
Le rayonnement de la classe b repecte ISED fixaient un environnement non
contrôlés. Installation et mise en œuvre de ce matériel devrait avec échangeur distance
minimale entre 20 cm tonon corps
.Lanceurs ou ne peuvent pas coexister cette antenne
ou capteurs avec d’autres.
IC Label Instructions:
The outside of final products that contains this module device must display a label
referring to the enclosed module. This exterior label can use wording such as:
“Contains Transmitter Module IC: 22745-MC16”,or “Contains IC: 22745-MC16”, Any
similar wording that expresses the same meaning may be used
Instructions d'étiquetage IC: L'extérieur des produits finis contenant ce module doit
afficher une étiquette faisant référence au module inclus. Cette étiquette extérieure peut
utiliser des libellés tels que: contient le module émetteur IC: “ 22745-MC16 ”ou“
contient: IC: 22745-MC16 ”, tout libellé similaire exprimant le même sens peut être
utilisé