User's Manual

DC
"Attention‐LimitedModularApproval
This RF Module is strictly limited to integration intobattery-poerated host devices.  Integration
into devices that are directly or indirectly connected to AC lines may be added via Class II
PermissiveChange."

(OEM) Integrator has to assure compliance of the entire end‐  the integrated RF

Module. Additional measurements (15B) and/or equipmentauthorizations(e.g Verification) may
needtobeaddresseddependingonco‐locationor issuesifapplicable.

Integratorisremindedto assurethattheseinstallationinstructionswillnotbemadeavailableto
theend‐userofthefinalhostdevice.

With the documented max output power
this RF Module meets the FCC SAR Exemption‐  

TheRFModuleispoweredby antennaisPCBantennaandtheantennagainis0dBi

Thefinalhostdevice,intowhichthisRFModuleisintegrated"has
tobelabelledwithanauxilliary
lablestatingtheFCCIDoftheRFModule,suchas"ContainsFCCID:2ACCRMA41"

This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1)thisdevicemaynotcauseharmfulinterference,and
(2) this device must
accept any interference received, including interference that may cause
undesiredoperation.

"Changesormodificationstothisunitnotexpresslyapproved by the party
responsibleforcompliancecouldvoidtheuser’sauthoritytooperatetheequipment."
product incl.
simultaenous transmission
so it
comply with any applicable RF exposure requirements in its final configuration.
,the