Specifications

5 Sample application
5.1Run the App:
The development kit comes pre-installed with the Alexa sample app. Following steps are
designed to help developers run the app and see the development kit in action.
Latest version of the Home Hub 100 users guide can be found here:
https://www.qualcomm.com/products/qca4020/tools-software
Please refer to this users guide for more details.
o Setup the AWS account as described in the Home Hub 100 users guide.
o The development kit comes with the sample app pre-installed.
o Make the hardware connections,
 On the QCA4020 development kit:
Make sure the power switch is set to OFF before handling the board.
Remove jumpers from J34 and J31. This will start the development kit in
Autoboot mode and run the application that is pre-flashed on the board.
Connect the micro-USB connector J6 to power source.
Connect the micro-USB connector J85 to your host PC. This will setup the serial comm port to
run the sample app.
 On the ASV1108 Audio board:
Connect the speaker to ASV1108 audio board.
Make sure that the Mute button on the audio board is set to “Mic On” and not
to “Mute”
o Once all the connections are made, Turn the power switch ON.
The sample app has a command line interface. On the host PC, open a serial console
using a port setting of 115200, 8, n, 1, and a CLI menu appears
o WLAN connection
Use the following commands to connect the development kit to Wi-Fi
wlan enable or 3 5
wlan connect "WiFi Hotspot" password WPA2 CCMP CCMP