Data Sheet

EH-ES101
Ehong
®
Professional Bluetooth Solutions Provider page 14 of 14
Figure 8: EH-ES101 pallet size.
11. Soldering Recommendations
EH-ES101 is compatible with industrial standard reflow profile for Pb-free solders. The
reflow profile used is dependent on the thermal mass of the entire populated PCB, heat
transfer efficiency of the oven and particular type of solder paste used. Consult the
datasheet of particular solder paste for profile configurations.
SMT stencil making requirements
 If Bluetooth module PIN pitch ≥ 0.25mm and other component PIN pitch ≥ 0.25mm,so you
choose SMT stencil thickness 0.15mm.
 If Bluetooth module PIN pitch ≥ 0.25mm and other component PIN pitch ≤ 0.25mm,so you
choose SMT Ladder stencil Bluetooth module thickness 0.15mm other component
thickness 0.13mm.
 Solder pad open via ratio Length 1:1.2, width 1:1.
12.
Contact Information
Sales: [e-mail]
Technical support: [e-mail]
Website: http://www.ehonglink.com
Tel: [phone]
Fax: [phone]
Address: Suite501,No.3 building,No.439 Jinglian road,Minhang district,Shanghai,China
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment .This equipment should be installed and operated with minimum distance 20cm between the radiator& your body.
FCC Label Instructions:
The outside of final products that contains this module device must display a label referring to the enclosed module. This exterior
label can use wording such as: “Contains Transmitter Module
FCC ID: 2ACCRES101”,or “Contains FCC ID: 2ACCRES101”, Any similar wording that expresses the same meaning may be
used