User's Guide

6 RTK setup method and tilt measurement
6.1 CORS login settings
1.The handbook has a network after loading the SIM card;
2.Turn on the CM-Survey software, Bluetooth or WIFI to connect the receiver;
3."Instrument Settings" → "Mobile Station" → "New" → "Handbook Network": network protocol to select CORS,
enter the server address and port, get the source list, choose to use the source list, enter username and password,
save and apply.
6.2 Radio send and receive settings
Radio mobile station settings:
1) Receiver power on;
2) Turn on the CM-Survey software, Bluetooth or WIFI connection receiver;
3) "Instrument Settings" → "Mobile Station" → "New" → "Radio": select the radio protocol, channel, Baud rate,
save and apply can be configured, configure a CM3 external radio station as a base station, protocol, channel,
Baud rate configuration and mobile station, the master interface of the handbook to view the mobile station
receiver receiving data.
Base External Radio - Bluetooth Settings:
1) Receiver power on;
2) FL3 radio power on, Bluetooth search receiver Bluetooth, so that FL3 and CM3 to establish a connection, CM3
will automatically switch to base station mode;
3) Configure FL3 radio protocol, channel, Baud rate lamp information, configuration can be completed, view FL3
radio Bluetooth light (BT) has been long on, differential light (RX/TX) one second flash configuration success.
6.3 Real-time dynamic RTK accuracy
Mobile station setup method:
1)The handbook is connected to the receiver via the CM-Survey software;
2)"Instrument Settings" → "Mobile Station" → "New" → "Handbook Network";
3)Network protocol select CORS, enter server address and port (CORS account), click to get the source list, select
the corresponding source list, enter username and password, save and apply;
4)After the main interface of the handbook shows that the receiver is fixed, the measurement interface takes
continuous point measurements according to the 1s interval, exports the point data and imports it into the RTKQC
software, so that the accuracy can be viewed.
6.4 Tilt measurement initialization method
1) Measurements interface, click The tilt measurement icon turns on the tilt function.