User's Guide

configuration
configuration" on the left
side of the page. You can
check:
 [Summary]
 [Antenna
parameter
settings]
 [Reference station
settings]
 [Receiver reset]
 [Language
switching]
 [Account
management]
 [HCPPP settings]
reference station information.
[Antenna parameter settings]Antenna parameter
settings can be set antenna quantity, antenna
manufacturer, antenna type, antenna number,
antenna height, height cut-off angle, PDOPlimits.
[Reference station settings] You can set the
reference station's manual start base station,
self-starting base station, self-start mobile station
mode, you can set the reference station
coordinates, support sampling average.
Note: There are several input methods for the
location of the reference station. You can click to
get the current position to set the reference
station location, this method of reference station
coordinates because it is measured in a single
point state of an antenna phase center
coordinates, not very accurate;
Sampling average, positioning limit is divided into
a single point and fixed, single point refers to a
single point of state can collect reference value
coordinate data; Collecting a number means
collecting so many points in total, and then taking
the average and automatically filling in the
incoming reference station location column. The
progress bar represents the percentage value of
the total number of collected coordinates.
Coordinate offset threshold, which sets the
difference between the current latitude and
longitude coordinates obtained by the base
station mode and the longitude and latitude
coordinates in the base station list.
Base station list, you can set up several fixed base
station location of the longitude and latitude
coordinates as a list of typing, when set up since
the start of the base station after the receiver
automatically match the nearest latitude and
longitude coordinates to start sending differential
data.
Click Save to save your current settings.
[Receiver reset] The receiver can be shut down,
restarted, satellite data cleared, and the
appearance settings restored. Restarting the
receiver means restarting the receiver, clearing
the satellite data refers to clearing the satellite