Installation Instructions

 %DVLF 2SHUDWLRQV (/3
 6HWWLQJ WKH =(52 3RLQW
31
8. BASIC OPERATIONS
In this section, basic R mode operations such as recalling a commodity, entering a tare
weight, weighing and issuing labels, etc. are explained.
8.1 Setting the ZERO point
The ZERO key may be used to make corrections for minor deviations in the zero
reference point. The scale may drift from zero due to environmental conditions, debris
on the platter or leaving objects on the platter for long periods of time. To correct this,
remove all objects and debris from the platter. When the ST tri-mark (
) is lit, press
the ZERO key.
Ex.)
The scale Weight display should now show zero. If the scale will not return to Zero,
contact your authorized service representative.
8.2 Recalling a Comm odity (PLU)
There are three methods of recalling a commodity or PLU. These methods are used to
recall Weigh, Non-Weigh and By Count mode commodities (PLU’s). The procedure is
the same for all of the PLU types.
8.2.1 Using the PLU key
To recall a PLU from memory input the PLU number using the numeric keys and
then press the PLU key.
Ex.) Recall PLU #12
Action: Enter 12 using the numeric keypad, then press the PLU key.