Installation Instructions

 0DLQ 0HQX (/3
 0DLQ 0HQX 0RGHV
29
7.1 Main Menu Modes
RMode
The R mode is used to perform most daily operations such as weighing
commodities, recalling programmed commodities and issuing labels. After
normal power on procedures the scale will be in the R mode. All transactions
performed in this mode are recorded and saved in memory for use by
management for Sales Reports.
XMode
Pressing the MODE key once will take you to the X mode. The X mode is used
to perform Sales Reports using information obtained during normal daily
operations of the scale. Several types of reports are available in the X mode.
There are both daily and monthly reports available. Some report categories
available are By PLU, By Department and By Group. Some other special
functions available are Exporting Sales Data and printing a PLU List. For a
detailed explanation of these functions please refer to the appropriate section(s)
of this manual.
SMode
Pressing the MODE key twice will take you to the S mode. The S mode is where
most of the programmed information used during daily operations is directly
entered at the scale. (The same information may also be entered using the XDB
Manager Software program where available.) There are several programming
items available, from selecting which information fields are visible when
programming a commodity or PLU to programming date and time controlled
discount sales. Each of the many functions is explained in the S mode
(Programming Mode) section of this manual.
ZMode
Pressing the MODE key three times will take you to the Z mode. The Z mode is
mainly used to reset information in the scale back to a factory default
configuration or clearing the programmed information out of memory. Most
types of programmed information may be conveniently reset or cleared
individually. Stored Sales Information can also be reset/cleared using the Z
mode. There are several other special functions available in the Z mode such as
compressing and recreating the commodity database, printing the system
activity log, printing the firmware upgrade information, printing the scale
calibration record and backing up and restoring programmed information.