User's Manual

ADSL MODEM USER MANUAL
- 8 -
2.3.4 ADSL MODEM WORK MODE CONFIGURATION
1． For different protocols, the users need to set ADSL Modem accordingly as listed below:
Table 2.2
ATM VC Protocol Use DNS User Name Password
√
PPPoE Enable
√ √
PPPoE
PPPoA
√
PPPoA Enable
√ √
Lower interface Default route
1483 Bridged
√
Disable
Lower interface IP Address Sub mask Gateway Address
1483 Routed
√ √ √ √
Lower interface IP Address Sub mask IPoA Mode Gateway Address 1577
Private Line
√ √ √
1577
√
Note: √ means configure according to ADSL service provider’s instructed value.
PPPoE can also be realized via third party dialup software.
PPPoE PPPoA 1483 Bridged 1483 Routed 1577 Private Line
User Manual
Reference Chapter
3.4 3.4 3.2 3.3 3.3
2． After getting through every page for parameters set-up, click “Submit” to save the value in ADSL
MODEM
3． Click the “Commit & reboot” on “Admin” Tab to enter the saving configuration page as Figure 2.3. Click
“Commit”button to save the setting. Click “Reboot” button to reboot the ADSL MODEM. The ADSL
MODEM will work on the new parameters.
Figure 2.3
2.3.5 ADSL MODEM SOFTWARE INTRODUCTION
The same toolbar will appear on different pages, for example“LAN config”is on the page“LAN”and
“
Routing
”
. You can modify on either page.