User's Manual

- 4 -
CONNECTION and USING
SYSTEM REQUIREMENT
• A computer with a network card with Ethernet interface.
HARDWARE CONNECTION
This device is no need to configure and you can follow the steps below to finish the hardware connection:
1. Connect Ethernet port?of the ADSL MODEM to 10/100BASE-T port of the computer using the
network cable that comes with the modem.
2. Use a telephone cord to connect the LINE port of the splitter and the RJ-11 port (the phone jack) on
the wall.
3. Use another telephone cord to connect the ADSL port of the splitter and the LINE port of the ADSL
Modem.
4. Use another telephone cord to connect the telephone set and the PHONE port of the splitter.
5. Plug in the power cord, and turn on the Power Switch?.
Figure 2
If you do not want go online and make phone calls simultaneously, please just use a telephone cord to connect
the LINE port of the ADSL Modem and the RJ-11 port (the phone jack) on the wall. In this case, the splitter is not
necessary.