User's Manual

DB108 Ethernet ADSL MODEM USER MANUAL
- 8 -
2.3.4 ADSL MODEM WORK MODE CONFIGURATION
1. For different protocols , the users need to set ADSL Modem accordingly as listed below:
Table 2.2
ATM VCC Protocol Use DNS User Name Password

PPPoE Enable
 
PPPoE
PPPoA

PPPoA Enable
 
Lower interface Default route
1483 Bridged

Disable
Lower interface IP Address Sub mask Gateway Address
1483 Routed
   
Lower interface IP Address Sub mask IPoA Mode Gateway Address 1577
Private Line
  
1577

Note:  means configure according to ADSL service provider’s instructed value.
PPPoE can also be realized via third part y dialup software.
PPPoE PPPoA 1483 Bridged 1483 Routed 1577 Private Line
User Manual
Reference Chapter
3.4 3.4 3.2 3.3 3.3
2. After getting through every page for parameters set-up, click “Submit” to save the value in ADSL MODEM
3. Click the “Commit & reboot” on “Admin” Tab to enter the saving configuration page as Figure 2.3. Click
Commitbutton to save the setting. Click “Reboot” button to reboot the ADSL MODEM . The ADSL
MODEM will work on the new parameters.