User's Manual

DB101 ADSL MODEM Manual
- 18 -
5 In the “TCP/IP Properties” dialog box select the “IP Address” page. Select the “Specify an IP address” radial
box and input the correct IP address and subnet mask (you will need to contact your service provider to get
the correct value of the IP address and subnet mask). Or Select the “obtain IP address automatically” to skip
the step 6.
6 Input the correct IP address of DNS configuration and the Gateway property page.
7 Click “OK” button to exit the “TCP/IP Property” dialog box.
8 Click “OK” button in the pop-up “Networks” dialog box to finish the configuration of TCP/IP.
9 After modifying the property of TCP/IP, the system reminds the user to restart (Note: You don’t need to
restart for Windows®2000). Click the “OK” button to restart the computer immediately in order to make
the new settings valid.
Windows® 2000
The configuration process is similar to Win98.
6. PPPoE CONFIGURATION
1Method one:
• Follow the “Driver Installation” procedures to install “WAN Driver” and set values for VPI, VCI and
Encapsulation mode (see Chapter 3)
• Follow the “Connection Setup” procedures to install “Dial-up”.
2Method two:
• Install LAN driver and set VPI, VCI and Encapsulation mode.
• Install “Third party dial-up software”, for example, Enternet300, WinPoet, RasPPPoE, etc.
• Use third party dial-up software to connect to the Internet.